The Nano is 1 design from the ipod mp3 player family members created by Apple. The fourth era of this design functions a lengthy slim case and a little, square touch LCD display on the front. All of the internal workings of the ipod are contained in a couple of little elements inside the case. If you have a fourth-era Nano and require to disassemble it, you can effortlessly do it oneself in a comparatively quick volume of time.
Points You are going to Require
- Guitar select Jeweler's Philips screwdriver Jeweler's slotted screwdriver
Pry off the white plastic bezel on the best and bottom of the ipod making use of a guitar decide on. The bezels will unclip from the Nano, so preserve your fingers previously mentioned them to cease them from flying away from you.
Get the electrical power change from below the top rated bezel and set it aside. It will be unsecured to anything at all when the bezel is taken out.
Get rid of the two little screws on the leading and the a few on the bottom of the ipod with the Philips screwdriver. Pry off the metal piece on the bottom of the ipod employing the suggestion of a jeweler's slotted screwdriver.
Raise the top rated metal piece out of the best of the ipod by gently prying it upward. It will Consider caught the moment it is approximately 1-fourth inch out of the case by the change on the back again of the ipod.
Pull the change on the back again of the ipod away and keep on to pull the contents out of the case. End pulling the moment you can see the cables inside proper underneath the bottom edge of the LCD display.
Compress the bottom edge of the glass previously mentioned the display into the case with your fingers. You are going to be able to use the flat device to pry the glass off from the top rated edge and Get the glass away from the ipod.
Raise the ribbon wire connecting the decrease-left corner of the display screen to the within of the ipod. This will disconnect the wire and permit you to cautiously pull the internal components totally out of the case.
Slide the flat instrument in between the battery and the back again of the Nano case to separate them. As soon as the battery is lifted up, you can begin to push it down out the bottom of the case till the locking cable is visible along the bottom of the battery.
Consider off the locking cable by lifting it up, and make certain no glue is keeping it in location. Slide the battery out the relaxation of the way from the case.
Slide the flat instrument involving the front of the case and metal backing plate of the clicker wheel to separate them. Push the clicking wheel down via the bottom of the case.
No comments:
Post a Comment