iPod Nano Battery Replacement Tips

The ipod Nano MP3 60GB product has been enhanced so battery daily life is up to twenty hrs on a single cost. As with all electronics, the battery for this MP3 player desires recharging and will sooner or later have to be changed. Batteries can be acquired at retail and on the web merchants. Apple recommends that new batteries be set up at taking part ipod Nano merchants. Some ipod Nano consumers obtain the battery and set up it at residence.

Resources Necessary

2 nylon Equipment, knife or scissors are Required for battery substitute. Light- or medium-bodyweight guitar picks have also been recommended. Metal Equipment will injury the ipod case and need to in no way be employed. The electrical power to the ipod need to be turned off just before commencing.

Opening the ipod

The player ought to be held flat and deal with up. Insert the device among the metal back again and acrylic lip on the side front. Pry open just sufficient to make a area enabling the 2nd device to be inserted. Operate the 2nd device close to the complete edge, which will lead to the metal back again to separate from the front. When the back again has separated, turn the ipod above and meticulously get rid of the back again cover.

Eliminating the Battery

3 wires coated with colored plastic insulation are soldered to the ipod and linked to the battery. These wires ought to be lower with a knife or scissors. The cuts ought to be as around the battery as probable to depart space for error. Strip the insulation a single/two inch from the end of the 3 wires soldered to the ipod. Get out and discard the old battery.

Set up New Battery

On the new battery, there are 3 skinny wires that are stripped one/four inch. These wires normally have white, orange and black plastic insulation matching the wires soldered to the player. Cautiously eliminate an added one particular/two inch of insulation devoid of cutting into the wires. A wire stripper performs very best for this activity, but a sharp razor knife or scissors can be utilized. There are 2 approaches to connect the new battery. The very first consists of twisting every single set of old and new wires jointly by color. Cover each and every set of wires with tape, producing confident no wire is left uncovered. Soldering the wires with each other is one more selection, but it is not suggested due to the fact the warmth from the soldering iron can harm the parts in the ipod.

Entire the Substitute

Lay the 3 sets of wires flat on the major board. Align the front and back again so the maintain change lines up with the case, and the ipod will snap with each other. The new battery ought to be entirely charged prior to use.