A case for any ipod product can be sewn with only standard sewing capabilities and a modest sum of cloth. The case thorough has dimensions for a traditional ipod, and has a flap at the top rated with a Velcro or snap enclosure, but the pattern can be quickly adjusted for other varieties of closures.
Items You may Will need
- Ornamental cloth Lining cloth (Scraps will almost certainly be adequate, but you Will need all around twelve inches by 4 inches of every single) Matching thread Sewing device or sewing needle Material marker/pencil/tailors' chalk Scissors Pins Velcro, snaps or other fasteners Iron
Sewing the ipod Case
Measure and draw a rectangle measuring eleven inches by three one/two inches of your exterior material and lining material, and minimize the rectangles out.
Iron your rectangles, and area them jointly with the appropriate sides going through. Pin along the edges.
Sew a straight line one/4 inch along all 4 sides, leaving a two-inch gap at 1 stop. Snip the 4 corners diagonally, all around, but not by means of the stitches.
Flip the rectangle within out from the two-inch gap, making use of a knitting needle or pencil to poke the corners into area, if required. Press, smoothing the seams flat with your fingers.
Hand sew the two-inch gap closed, tucking the raw edges within the rectangle.
Fold the sewn brief stop of the rectangle from the bottom in the direction of the open top rated stop with the lining going through out, overlapping by 4 one/4 inches. Pin the overlapping side edges jointly.
Sew along the overlapping elements of the sides, leaving a one/4 inch seam. Turn the pocket you have developed inside of out.
At the center position of the lining-side of the flap of the ipod case, hand sew a modest square of Velcro or snap, catching only the lining cloth with your stitches. Sew the other portion of the Velcro/snap to the position on the front of the case in which the closure touches. If making use of other fastening notions, comply with guidelines on the packaging.
No comments:
Post a Comment