Welcome to the iPodRepairSquad.com ipod Nano Gen one disassembly manual. These models are little and fragile so make sure you use treatment the moment managing your unit.
Items You may Will need
- Instruments Essential ? Soft Resources - utilised to open the case devoid of scratching. Offered at www.ipodrepairsquad.com ? Little Phillips head screwdriver - #00
Opening the Case
? Be positive the Maintain Change is turned on. You may see orange as soon as you have the Maintain in the proper placement.
? Employing one soft instrument wedge it into the facet of the ipod. It can be desired to keep away from the Maintain Change and the headphone jack.
? Making use of a aspect to facet movement, loosen the ipod even though gently prying up and down. It's beneficial to insert 2 soft Instruments at the moment, Employing 1 to Maintain the gap open and the other to slide.
? There are many clips keeping the case in place, so function your way about and pop 1 facet off initial, then move forward to the leading or bottom and the case ought to snap proper off.
Dislodging the Battery
? Employing a soft device gently pry up on the battery from the edge proven. It's held on with some adhesive so You are going to have to operate all around the facet as nicely.
? When it really is loose you really should be in a position to flip the battery out but be cautious simply because it can be nonetheless soldered to the logic board.
? If you're changing the battery you can both use the soldering technique or the twisting strategy. These could be coated in separate manuals in the long term. For now depart the battery connected.
Getting rid of the Logic Board
? There are 4 screws to eliminate as demonstrated with the Red arrows in the image over. These could be coated with tape. Be watchful not to strip the screws.
No cost Logic Board From Clips
? Be confident to use a flat screwdriver to loosen the logic board from the 4 clips demonstrated previously mentioned so You are going to have far more place to operate with ahead of you move forward to the up coming phase.
Taking away the ClickWheel Ribbon
? We have located the top way is to Maintain the Nano involving your thumb and very first 2 fingers. You will not likely have considerably space to operate but it can be adequate to get a tiny flat head screwdriver in there and raise the clip up.
? The ribbon is held in place by a connector on the logic board (see subsequent stage.)
? The black latch desires to be flipped to the up place as demonstrated previously mentioned and then the cable can be quickly taken out. If you might be keeping it like demonstrated flip the latch in the direction of your thumb.
Further image of ClickWheel Connector referenced previously mentioned
Taking away the LCD
? The LCD is eliminated in the exact same way as the ClickWheel. Be confident not to harm the black clips.
? The black clips are a bit tougher to snap back again into place than they are to snap up, so we suggest Employing a flat instrument so as to not place as well a lot stress on any 1 stage of the black clip.
LCD is Now Totally free
Operate in reverse order to set up the Essential part you Want. If you have concerns really feel Free of charge to get in touch with us at customerservice@ipodrepairsquad.com or one-888-Ipod-Repair
No comments:
Post a Comment