Take Apart an iPod Nano 5th Generation

Realizing how to consider apart an ipod Nano fifth era can be a beneficial issue. Although these iPods are identified to be amid the most trustworthy MP3 gamers, the truth stays that they are not best and points can go incorrect with them. Anyone who has a tiny know-how all around the internal workings of an ipod might repair several of the difficulties, but 1st he need to realize how to take the ipod open.

Issues You are going to Require

Flat utility knife

Open the blade on the flat utility knife. The blade is typically no a lot more than a few of inches extensive. A blade that is as well broad may possibly not work. Right after the blade has been opened, spot the blade into the side of the ipod. It need to in shape within of a tiny crack in the white (or black) plastic that safeguards the metal base all around the device.

Following the blade has been pushed in to the factor at which it are not able to go additionally, get started to little by little move the blade in a downward movement toward the within of the ipod. Little by little push the knife in deeper. If performed the right way, the metal that addresses the ipod will start to separate from the plastic somewhat. This will depart adequate place for the knife to be in a position to slide amongst the plastic and metal.

Get started to move the knife downward gradually so that its blade commences to move upward (photograph a lever). This must be carried out little by little to prevent breaking the plastic covering. There is an edge to the plastic that the knife need to be capable to grip.

Pay attention for the "pop." The moment that is heard, take away the knife from the ipod and set it to the side. Commence to pull out the plastic covering with your fingers. As prolonged as one side is out, the other side need to too arrive out rather quickly.

Exchange the cover. Right after finishing the work that desires to be performed inside of of the ipod, changing the cover is pretty basic. Employing your fingers, slide one side of the plastic covering back again into location at an angle. As soon as the covering is in spot, get started to push the other side down. Make confident the initial side does not move out of spot. Push on the two sides until finally a click on is heard.