Replace an iPod Nano Cover

Changing your scratched and scarred cover is like providing a clean paint task to your ipod Nano. Nano addresses arrive in a selection of colours and styles, permitting you to update your ipod to match your style. You can substitute the cover in a couple of actions. All you will require is a little flat-head screwdriver and a piece of skinny tough plastic this kind of as a guitar choose or little paint scraper to use as a wedge.

Eliminate the Back again Cover

Slip the wedge in between the two items of the cover and operate it along the edges to loosen the casing. You can tape the edges of the ipod Nano cover to decrease the probabilities of scratching it in case you need to reuse it.

Pry the Back again cover off with the wedge. You may require to separate the casing with the wedge to prop the casing open and the screwdriver to pry the items apart. Carry out this stage as gently as feasible so as not to disturb the internal wiring.

Disconnect the Tough Drive

Eliminate the battery from the challenging drive by gently popping it off the board with the screwdriver or wedge. The battery will be related to the challenging drive by wires, so be mindful not to tear them. Spot the battery to the facet of the tough drive. If you are unpleasant functioning close to the battery wires, you can disconnect the battery entirely by pinching the best of the connector keeping the wires to the battery.

Unscrew the challenging drive from the front cover. There are 4 screws, a few around the base of the challenging drive around the synch port and one particular in the center of the board on the left. If the screws are coated by tape, Take away it. Elimination of the tape will not have an effect on the Nano's overall performance.

Disconnect the Front Cover

Flip the Nano over and gently raise the cover up from the base. You'll see a ribbon connecting the difficult drive to the front cover. Slide the black piece following to in which the ribbon is related to the difficult drive--this will release the ribbon from the front cover, which you can now Take away.

Set the Nano Back again With each other

Connect the fresh cover to the Nano's difficult drive by connecting the ribbon to the challenging drive and sliding the black piece into Spot. Flip the Nano over and screw the challenging drive Back again onto the front cover.

Reconnect the battery wires if you disconnected them before. Exchange the battery in its challenging-drive bay and press down to snap it into Location. Area the fresh Back again cover over the challenging drive and lock the two items With each other by pressing them firmly Collectively.