Remove the Battery in a 2006 iPod Nano

The Lithium-ion battery inside of your ipod Nano really should very last involving two and a few decades of day-to-day use ahead of it desires to be changed. Changing it by way of Apple is an high-priced proposition, but if you might be helpful with a soldering iron, you can exchange the aspect by yourself. Even so, opening your ipod will void its guarantee, and if you will need to set up a new battery, you may really should buy a single from a 3rd get together.

Items You may Will need

1st era ipod Nano ipod opening instrument or skinny knife Soldering iron

Flip your ipod off and take away any addresses, cables or headphones at the moment related. Area it on a clear, continual surface area. Flip the ipod about so that the mirrored metal back again is going through up.

Wedge the separator instrument or knife into the appropriate side of the case, exactly where the black or white front of the ipod meets the metal back again. Gently separate the two halves of the case. Following lifting the back again above a quarter of an inch, pay attention for the "pop" of the plastic tabs disengaging from the metal back again.

Pull the back again of the ipod off of the case. Observe the battery (the only aspect separate from the circuit board.) If the battery is bloated, warped or leaking, Quit. If you can see harm to the battery, phone your nearby hazardous waste recycling facility for disposal directions. If the battery seems regular, carry on to the subsequent stage.

Plug in your soldering iron and wait for it to warmth up. Soon after 5 minutes (or Even so lengthy it requires your iron to warmth), maintain the iron to the solder pad on the white wire connecting the battery to the circuit board. Maintain the iron in Area for more than 20 seconds. When the aspect compound is in a liquid state, gently pull the wire off of the circuit board.

Repeat Phase 4 for the red and black wires straight adjacent to the white wire. When all a few wires are totally free of the circuit board, gently pull the battery off of the ipod case (it is secured with a little piece of tape on the opposite side.) Set the battery aside and unplug the soldering iron.